Solar Panels in a Typhoon: What Holds Up on Philippine Roofs

Published 2026-10-01 · By TipidKuryente Editorial · Calculator figures use the sourced dataset

Putting panels on a roof in the typhoon belt sounds risky, and every installer here gets asked about it. In practice, a certified panel that’s mounted properly is rarely the thing that fails. When a solar roof does get damaged in a typhoon, it’s usually the mounting, the roof underneath, or something the wind blew into it.

What the building code asks for

Buildings here are designed to the National Structural Code of the Philippines (NSCP), and its 2015 edition raised the wind speeds buildings have to withstand. One study of a Philippine site found the design gust rose from 200 km/h under the 2001 code to 255 km/h under the 2015 one, after storms like Super Typhoon Lawin, which gusted to 315 km/h in 2016. Your roof, and anything bolted to it, should be built for your area’s figure in the current code.

What the panels are tested to

Every certified panel has passed the IEC 61215 load test: 2,400 pascals of pressure on the front and pull on the back, repeated three times, to simulate wind pushing and sucking on it. The datasheet shows the rating, and some panels are rated higher on the front. Ask for the datasheet, and check that the rating still applies to the way your installer clamps the panels, because it assumes the manufacturer’s clamping positions.

How to have them mounted

  • Fixed into the roof frame. The rails should be anchored to the purlins or rafters, not just screwed through the roofing sheet.
  • Rust-proof hardware. Use stainless or hot-dip galvanized bolts and clamps. Near the sea in particular, cheap zinc-plated hardware rusts loose within a few years.
  • Away from the edges. Wind suction is strongest at the edges, corners and ridge of a roof, and the code gives those spots higher design pressures. Leave a gap there when laying out the panels; the roof area calculator shows how many still fit.
  • Low tilt on exposed roofs. The steeper the tilt, the more wind a panel catches.
  • Ask for the plan. You need a signed electrical plan for the permit and the net-metering application anyway. Ask how the mounting was designed to handle wind, and get the answer in writing.

Before a typhoon

  • Check the mounting from the ground, or from a ladder at the edge of the roof, a few days ahead, not on the day itself. Loose clamps should be fixed while the weather is calm.
  • Clear the roof and yard of anything that could fly into the panels.
  • Don’t cover the panels with a tarp. It turns them into a sail.
  • A grid-tie system shuts itself off when the grid goes down. That’s deliberate. A hybrid keeps the circuits you chose running from the battery, so charge it fully before the storm.

After a typhoon

  • Stay off the roof and away from damaged panels. A panel makes electricity whenever light hits it, broken or not, and a grid outage doesn’t make it safe.
  • Take photos of the damage before anything gets moved, then call the installer.
  • Check the monitoring app. If one string’s output has dropped, there may be damage you can’t see from the ground.

Insurance

Check that your home insurance covers the panels, since solar often has to be declared separately. A GSIS solar loan includes three years of free cover against fire, earthquake, lightning and typhoon. Keep the receipts and photos of the finished installation, because an insurer and a warranty claim will both ask for them. See maintenance and cleaning for the yearly check to do before typhoon season.

Sources